Posts

Paramatric Design using Dynamo-Project 2

Image
I conducted project 2 based on the same building.   Phoenix International Media Center   Completed: 2014 Height: 55 m Total floor area: 64,973 square meters Land area: 18,821 square meters Building owner: Phoenix Satellite Designer: Beijing Institute of Architectural Design (Group) Co., Ltd (BIAD)   Developer: Phoenix Satellite Television I did three parts in project 2. 1. Conceptual Mass Design using Dynamo 2. Parametric design of of using family parameters in Dynamo 3. Color change of curtain panel 1. I used the same method in the mass build in Dynamo. Create a circle, put segmentation points on the circle and build the ellipse on the point, rotate the ellipse for a certain angle. Then I build the solid form with the rotated ellipse. The challenge is to calculate the angle and put the mass of Dynamo in a Revit project. 2. Parametric design of of using family parameters in Dynamo I used the parameter in the mass family which is the r

Paramatric Design using Revit-Project 1: Case study

Image
ARCH653 Project 1   Phoenix International Media Center   Completed: 2014 Height: 55 m Total floor area: 64,973 square meters Land area: 18,821 square meters Building owner: Phoenix Satellite Designer: Beijing Institute of Architectural Design (Group) Co., Ltd (BIAD)   Developer: Phoenix Satellite Television Floor plan of Level 0 and Level 1 (Image from Beijing Institute of Architectural Design (Group) Co., Ltd (BIAD)) Phoenix International Media Center located between the third and fourth ring roads in Chaoyang District of Beijing. The Phoenix International Media Center is a steel torus of structure enclosed with 3,800 glass panels. It was designed by Beijing Institute of Architectural Design (BIAD). Image from Beijing Institute of Architectural Design (Group) Co., Ltd (BIAD)) I intend to build a parametric model based on the calculation the turning angle of the surface of each section. I found